Are you looking for a quick and easy DIY installation or repair for your coax cable? Our N Female Bulkhead connectors for RG58 & LMR-195 will provide a simple solution for your wiring needs. The bulkhead connector consists of the connector housing, pin, and ferrule for termination. As well as a grommet, nut, washer for panel mount installation. For this installation you will need: A coax stripper, coax cable, a soldering iron, a crimp tool, and the BNC connector. Keep in mind, you will want to make sure that your coax stripper, crimp tool, and connector match the coax cable that you are installing. Start by inserting the ferrule over the outer jacket of the cable. Then, using your cable stripper, strip back the outer jacket and dielectric. The advantage of using a cable stripper is that it will strip back the jacket and dielectric at the same time. Pull back the braided shield and Insert the pin onto the center conductor. Solder the pin onto the center conductor and insert the connector housing over the cable. Apply pressure and twist to make sure that connector fits into place. Then, slide up the ferrule to the base of the connector, folding the shield with it. Crimp the ferrule onto the outer jacket to complete termination. Give the connector a small tug to make sure it is properly seated. Congratulations, you have successfully installed the N Female Bulkhead connector. For all of your cable and connector needs, choose Show Me Cables

N Female Bulkhead Crimp Connector - RG58 & LMR-195