Cat7

Ethernet is one of the most important types of cables today, being used to connect all manner of technology around the world to the Internet. While many stores today have pre-made ethernet cables available, sometimes another option is needed. Users may need a cable in an unusual size or just need to replace a broken connector. This guide will show users how to put an RJ45 connector onto the end of bare ethernet cable.

Before jumping into the main guide, there is an easy fix if you have a connector where the release tab broke off. When the tab breaks, the cable will not lock into place and have trouble maintaining a connection. This can be easily fixed with a Quick Snap Latch, which is a much easier repair than replacing the whole connector. If a broken latch is the only issue, grab one of those for a simple repair that will only take a few seconds.

A video guide detailing the below steps can be found at the bottom of the article.

Step 1: Gathering the Supplies

There are a few simple supplies that will be needed for an installation or repair. The key components are the bare ethernet cable and the RJ45 connectors. Beyond that, just a few tools are needed. A cable stripper and modular crimper are essential in any scenario. A pair of

Ethernet is one of the most common types of cables, used to connect devices like computers and routers to the Internet. The end of an ethernet cable, an RJ45 connector, looks similar to the end of a phone cable, an RJ12 modem cable, but bigger. While phone cables have four to six wires on the inside, ethernet cables use eight. Ethernet cables come in both solid and stranded variants.

Ethernet Categories

There are a few different variations of ethernet, the foremost being the cable category. This type of cable is abbreviated as “Cat#”, with higher numbers being newer versions of ethernet capable of faster signal speeds. These categories are defined by the Institute of Electrical and Electronic Engineers (IEEE).

Cat5e

Cat5e is an upgraded version of the original Cat5 cable and the current standard version of ethernet. It is capable of data speeds up to 1 Gbps (gigabyte per second) with a bandwidth of 350 MHz (MegaHertz).

Cat6

Cat6 is the next step up and will become the new standard once Cat5e is inevitably phased out. These can support speeds up to 10 Gbps, ten times faster than Cat5e, with bandwidth of 550 MHz. Currently, this level of speed is overkill for at-home use. They are more common in facilities setting up basic networks, like small businesses or schools.

Cat6a

Cat6a (“a” meaning “augmented”) have the same 10 Gbps maximum speed as Cat6 but better overall performance, including a 750 Mhz bandwidth. These cables are thicker and better shielded, reducing signal interference and allowing them to retain high signal speed over

P#85-700-150 BK This is the Cat7 Shielded Solid Outdoor PVC Cable. Experience the next generation of networking with Cat7 bulk cable from ShowMeCables. This cable enables 10-Gigabit data transmission over a 4-connector twisted-pair copper cable, allowing connection distances of up to 100 meters. This cable is rated for outdoor use, it also proposes a new measurement for Power-Sum Alien Crosstalk to 750 MHz. Alien Crosstalk is a coupled signal in a disturbed pair arising from a signal in a neighboring cable. This CM rated, UV resistant cable features a protective PVC jacket, Overall tin-copper braided shield, as well as foil shielded twisted pairs for maximum EMI rejection, and solid 23 AWG copper conductors. The Cat7 Shielded Solid Outdoor PVC Cable is the best solution for your next networking project. For more information on our products please contact our customer service department at 888 518 9505