VHF/UHF/FM Variable Gain Amplifier - 47 to 1000MHz - 25 dB

SKU
27-160-025
Bandwidth 47 to 1000MHz | Max Gain 25dB | Gain Control
Rating:
88% of 100
Quantity Discount Pricing
1-2 3-5 6-7 8-9 10+
$23.31 $22.04 $20.79 $19.56 $18.35

VHF/UHF/FM Variable Gain Amplifier - 47 to 1000MHz - 25 dB

The 25dB VHF/UHF/FM Amplifiers w/ variable gain are used to boost the signal from your antenna to your TV or splitter. This amplifier features a variable gain control to provide up to 25db of gain. Simply install the amplifier to your antenna for up to a 25dB boost. Amplifiers are required when the signal is too weak or for long cable runs over 100 feet. This amplifier supports signals from 47 to 1000 MHz.

Features:

  • Bandwidth: 47-1000MHz
  • Maximum Input: VHF 40dB MV / UHF 20dB MV
  • Gain:
    • 54-300Mhz: 25dB
    • 300-806Mhz: 22dB
    • 900Mhz: 18dB
  • Noise Figure: VHF 6dB / UHF 8dB
  • Gain Control: 10dB
  • Dimensions: 5.5in L x 3.25in W x 1.5in H
  • Outer Shell: Iron
      Write Your Own Review
      You're reviewing:VHF/UHF/FM Variable Gain Amplifier - 47 to 1000MHz - 25 dB
      Your Rating

      Proposition 65

      WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

      RoHS*

      Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union. It stands for Restriction of Hazardous Substances Directive.

      REACH*
      REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment. It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.

      WEEE*

      The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community. It stands for Wate Electrical and Electronic Equipment Directive.

      * The following information is for information purposes only. It does not guarantee that the product adheres to the following standards. Please check the product description for specific certifications.

      Q: Where should I install the coax amplifier?


      A: Amplifiers should be installed as close as possible to the signal source. For in-line amplifiers outside next to the antenna or satellite dish would be best. Wall powered amplifiers should be installed where the signal line enters the building.