Cable Clip for Dual Coax/Ethernet Cables with 7/8 Inch Screw - 100 Pack
Route & Install 2 Coax/Ethernet Cables | Pre-Installed 7/8 Inch Screw | Plastic | Works with cables up to 6mm OD
Cable Clip for Dual Coax/Ethenert Cables with 7/8 Inch Screw - 100 Pack - Black
Cable clips are a quick and convenient way to route and install cable without damaging the jacket. They can be used for pre-wire or finished construction. They are made from high impact ABS plastic and can withstand the forces of installation. The pre-installed 7/8 in. screw makes it easy to grab and put in place. They can be installed using a phillips head screw driver. Unlike staples, the molded plastic clips won't damage or slice the cable jacket. Sold in packs of 100.
- Fits two coax or ethernet cables up to 6mm in diameter
- Pre-installed 7/8 in. screw - 1/2 in. driving depth
- High impact ABS plastic
- 100 pack
Q: Will cable clips damage my cable?
A: Absolutely not. The molded plastic is free from sharp edges so you can safely use these during installation.
Q: Are they reusable?
A: While it is possible to pull them out and reuse them often times the clips are damaged while removing them. We recommend using a new clip each time.
Q: What is the difference between a nail clip and a screw clip?
A: Nail clips are quick to install and are slightly less permanent than screw clilps. They can be installed into a wider variety of material such as wood mortar and brick. Screw clips take longer to install but will provide a long lasting cable routing solution.