Cable Clip for Dual Coax/Ethernet Cables with 1/2 Inch Screw - 100 Pack
Cable Clip for Dual Coax/Ethenert Cables with 1/2 Inch Screw - 100 Pack - Black
Cable clips are a quick and convenient way to route and install cable without damaging the jacket. They can be used for pre-wire or finished construction. They are made from high impact ABS plastic and can withstand the forces of installation. The pre-installed 1/2 in. screw makes it easy to grab and put in place. They can be installed using a phillips head screw driver. Unlike staples, the molded plastic clips won't damage or slice the cable jacket. Sold in packs of 100.
Features:
- Fits two coax or ethernet cables up to 6mm in diameter
- Pre-installed 1/2 in. screw
- High impact ABS plastic
- Black
- 100 pack
Proposition 65
WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
RoHS*
Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union. It stands for Restriction of Hazardous Substances Directive.
REACH*
REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment. It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.
WEEE*
The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community. It stands for Wate Electrical and Electronic Equipment Directive.
* The following information is for information purposes only. It does not guarantee that the product adheres to the following standards. Please check the product description for specific certifications.
Q: Will cable clips damage my cable?
A: Absolutely not. The molded plastic is free from sharp edges so you can safely use these during installation.
Q: Are they reusable?
A: While it is possible to pull them out and reuse them often times the clips are damaged while removing them. We recommend using a new clip each time.
Q: What is the difference between a nail clip and a screw clip?
A: Nail clips are quick to install and are slightly less permanent than screw clilps. They can be installed into a wider variety of material such as wood mortar and brick. Screw clips take longer to install but will provide a long lasting cable routing solution.
