Belden CAT6+ REVConnect Patch Panel

Belden CAT6+ REVConnect Patch Panel

CAT6+ REVConnect Patch Panel

This Belden Patch Panel allow for maximum efficiency when space is valuable. A patch panel is a block which contains numerous RJ45 ports. Patch panels are used for connecting incoming and outgoing lines of a local area network (LAN) or a telecommunication system. In a LAN the patch panel connects the networks computers to each other and any switches or hubs with patch cables. Patch panels also give the benefit of organization for a clean install.


  • Footprint/Type: KeyConnect
  • Tool Compatibility: REVConnect Termination Tool (RVUTT01)
  • Plug /Jack Compatibility: RJ45
  • Cable/Connector Retention: 15 lbs
  • Connector/Hardware Retention: 20 lbs
  • Plug/Connector Retention: 11.250 lbs


  • UL Rating: UL94V-0
  • Data Category: Category 6+
  • Telecommunications Standards: Category 6 - TIA 568.C.2, Category 6 - ISO/IEC 11801:2002 Ed.2
  • IEEE Specification: Power Over Ethernet (PoE) IEEE 802.3at type 1 and 2 (up to 30W), IEEE802.3bt/D1.7 type 3 and 4 (up to 100W), CISCO UPOE (up to 60W), Power over HDBase TTM (up to 100W)

Other Standards: FCC part 68, Subpart F, IEC 60603-7, UL 1863

Write Your Own Review
You're reviewing:Belden CAT6+ REVConnect Patch Panel
Your Rating

Proposition 65

WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to


Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union. It stands for Restriction of Hazardous Substances Directive.

REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment. It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.


The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community. It stands for Wate Electrical and Electronic Equipment Directive.

* The following information is for information purposes only. It does not guarantee that the product adheres to the following standards. Please check the product description for specific certifications.