2mm Desoldering Braid - 5 FT
| Quantity Discount Pricing | ||||
|---|---|---|---|---|
| 1-2 | 3-5 | 6-7 | 8-9 | 10+ |
| $1.18 | $1.11 | $1.09 | $1.07 | $1.01 |
2mm Desoldering Braid - 5 FT
When doing solder repair it is best to remove the old solder. This desoldering braid is simply a spool of cloth wick coated with copper. It removes solder by attracting it into the wick through capillary action.
Features:
- Length: 5 feet
- 2.0mm thick
- Thick soldering wick used for removing solder
Proposition 65
WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
RoHS*
Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union. It stands for Restriction of Hazardous Substances Directive.
REACH*
REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment. It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.
WEEE*
The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community. It stands for Wate Electrical and Electronic Equipment Directive.
* The following information is for information purposes only. It does not guarantee that the product adheres to the following standards. Please check the product description for specific certifications.
Q: When selecting a soldering Iron how many watts do I need?
A: Typically soldering irons may have a power rating of between 15 to 30 watts. They are fine for most work. A higher wattage does not mean that the iron runs hotter it simply means that there is more power in reserve for coping with larger joints. Consider a higher wattage iron simply as being more resilient when it comes to heavier-duty work because it won't cool down so quickly.
Q: Is my new soldering iron ready to solder out of the box?
A: No. An important step to good soldering is tinning. Tinning should be done to new irons replacement tips and older iron tips. While the iron is warming up hold the solder against the tip and wait until the solder begins melt. As soon as the solder begins to melt coat the tip surface completely and wipe the tip off with a wet sponge. The end result should be a thin layer of solder coating the tip.