New Work Box / Pre Wire Box
New Work Box / Pre Wire Box - Single Gang
The New Work Box is used for new construction projects where mounting directly to studs or joints is the method of installation. The sturdy New Work Box is the perfect solution for providing wall plate receptacles. Run a cable through the New Work Box and cover with a personalized Wall Plate.
- Single Gang
- Cut-Out Hole Size: 2-1/8IN x 3-3/4IN
- Class 2 Wiring Only
- No 120 Volt Devices Should Be Used With This Bracket
WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union. It stands for Restriction of Hazardous Substances Directive.
REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment. It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.
The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community. It stands for Wate Electrical and Electronic Equipment Directive.
* The following information is for information purposes only. It does not guarantee that the product adheres to the following standards. Please check the product description for specific certifications.
Q: What is the difference between a Junction Box and a Mounting box?
A: A junction box is in two pieces for a more flexible installation while a mounting box is in one piece.
Q: What is the difference between an Old-Work Box and a New-Work Box?
A: Old-Work boxes are designed to be installed after drywall has been hung. New-Work boxes are used for new construction boxes or applications where mounting directly to studs or joists is possible.