Belden 9842 - 2 Pair 24 AWG Shielded PVC Cable for EIA RS-485

SKU
Belden 9842 Bulk Cable

2 Pairs | 24 AWG | 120 Ohm | Stranded Tinned Copper | PE PVC Insulation | Shielded | 24 AWG Drain Wire | CM PVC Jacket

Belden 984 is a low capacitance serial cable used in EIA RS-485 applications. This cable has a nominal impedence of 120 Ohm and comes with 2 pairs of 24 AWG stranded tinned copper conductors. The conductors are insulated with polyethlyene PVC. This cable is protected from RFI and EMI interference by a 100% Aluminum foil-Polyester tape Beldfoil® shield, plus a 90% tinned copper braid. The jacket is CM rated PVC.

Features:

  • 120 Ohm
  • 2 Pair/24 AWG
  • Stranded Tinned Copper Conductors
  • 24 AWG Drain Wire
  • 100% Aluminum Foil-Polyester Tape Beldfoil® Shield
  • 90% Tinned Copper Braided Shield
  • Polyethlyene PVC Insulation
  • CM Rated PVC Jacket
  • UL Listed
  • RoHS Certified
  • Sold per ft.
  • Max Continuous Length: 1000 FT

Please note: All products that are bought per foot are non-returnable.

Any amount of cable you order above the maximum continuous length of 1000 FT will be sent in separate pieces.

Write Your Own Review
You're reviewing:Belden 9842 - 2 Pair 24 AWG Shielded PVC Cable for EIA RS-485
Your Rating

Proposition 65

WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

RoHS*

Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union.  It stands for Restriction of Hazardous Substances Directive.

REACH*
REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment.  It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.

WEEE*

The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community.  It stands for Wate Electrical and Electronic Equipment Directive.

* The following information is for information purposes only.  It does not guarantee that the product adheres to the following standards.  Please check the product description for specific certifications.