Belden 1421A - 4 Pair 24 AWG Shielded Low Capacitance Serial Cable for EIA RS-232/422

SKU
Belden 1421A Bulk Cable

4 Pair | 24 AWG | 100 Ohm | Stranded Tinned Copper | Insulated | Shielded | 24 AWG Drain Wire | CM PVC Jacket

Belden 1421A is a low capacitance serial computer cable used in EIA RS-232/422 applications. This cable has a nominal impedence of 100 Ohm and comes with 4 pairs of 24 AWG stranded tinned copper conductors. This cable is protected from RFI and EMI interference by a 100% tinned copper Beldfoil® shield. The conductors are insulated by Datalene® foamed polyethylene. This insulation features a low dielectric constant and a dissipation factor for high speed, low distortion data transfers. The jacket is CM rated PVC.

Features:

  • 100 Ohm
  • 4Pair/24 AWG
  • Stranded Tinned Copper Conductors
  • 24 AWG Drain Wire
  • 100% Tinned Copper Beldfoil® Shield
  • Datalene® insulation
  • CM Rated PVC Jacket
  • UL Listed
  • RoHS Certified
  • Sold per ft.
  • Max Continuous Length: 500 FT

Please note: All products that are bought per foot are non-returnable.

Any amount of cable you order above the maximum continuous length of 500 FT will be sent in separate pieces.

Write Your Own Review
You're reviewing:Belden 1421A - 4 Pair 24 AWG Shielded Low Capacitance Serial Cable for EIA RS-232/422
Your Rating

Proposition 65

WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

RoHS*

Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union.  It stands for Restriction of Hazardous Substances Directive.

REACH*
REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment.  It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.

WEEE*

The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community.  It stands for Wate Electrical and Electronic Equipment Directive.

* The following information is for information purposes only.  It does not guarantee that the product adheres to the following standards.  Please check the product description for specific certifications.