Cat6 Ethernet Cables - 50FT Red Cat6 Crossover Patch Cable
Crossover Ethernet cables are designed to allow two devices, such as computers, to communicate directly. Standard Ethernet cables (called "straight through" as opposed to crossover) require that a device be connected to a switch or hub before communicating with another device. These hubs or switches match the transmission point from one end of the cable to the receiving point at the other end. A crossover cable switches the wires, allowing the devices to bypass the hub or switch.
Q: What are Cat6 Ethernet Cables? A: Cat6 Ethernet cables are a higher-bandwidth version of Cat5e Ethernet Cables which are the most commonly used networking cables.
Q: Does this hook up my computer to my modem? A: Yes! You can use these cables to connect your computer modem or router. Most household networks and internet connection devices use Cat5e.
Q: What does Cat6 mean? A: Cat6 is short for Category 6. Cat6 is the next level up from Cat5e. See below.
Q: What is the difference between Cat5e & Cat6? A: Cat6 is faster and is used for top of the line networks. While Cat6 will work just as well as Cat5e the cables alone will not improve the speed of your network.
Q: Will this make my internet connection faster? A: No; the cable alone will not make your connection faster it only adds more bandwidth. Imagine that the cable is a highway: adding more bandwidth is like adding more lanes. It allows more traffic but it doesn't make your car faster. To increase the speed of your internet connection you must order faster service from your iSP.
Q: Can I use these cables for my Playstation XBox or other gaming system? A: Yes. You can use either these cables or Cat5e patch cables.
Q: Do these cables come with plugs on the ends? A: Yes. The cables on this page are pre-terminated so they are ready to use right out of the box.
Q: Are these the same cables I would buy at my local electronics store? A: Yes! Our cables may not be the same brand that you would buy at a Radio Shack or Best Buy but the cables perform the same and are tested in the same way.
Q: Why do these cables cost so much less than cables at other stores? A: There are two main reasons. We only sell our cables on the Web so we do not have the expenses and overhead required to run a brick-and-mortar store. The second reason is that we manufacture our own cables. Brand-name cables are well-known for being overpriced while our cables have the exact same technical specifications.
Q: How are you patch cables measured? A: Our patch cables are measured from tip-to-tip. There is however a tolerance to be aware of. This tolerance is listed as (+ or –) in inches on the spec sheet for each product. For this cable the tolerance is between 5 - 7 inches.
