Satellite In-Line Amplifier - 900 to 2400MHz - 20 dB

Bandwidth 900 to 2400MHz | Max Gain 20B | Line Powered | Power Passing | Outdoor Rated
Quantity Discount Pricing
1-2 3-5 6-7 8-9 10+
$11.21 $10.00 $9.41 $8.83 $8.26

Satellite In-Line Amplifier - 900 to 2400MHz - 20 dB

The 20dB Satellite In-Line Amplifier are used to boost the signal from your satellite to your receiver or multiswitch. Simply install the amplifier at the satellite dish or signal source for an instant 20dB boost. In-line amplifiers are required when the signal is too weak or for long cable runs over 100 feet. This amplifier supports signals from 900 to 2400 MHz.


  • 20dB +/- 1dB Gain
  • Line Powered
  • Power Passing
  • Low Noise Figure: 4dB Max
  • Outdoor Rated
  • Bandwidth 900 to 2400 MHz
  • Power Consumption: 22VDC 40mA
Write Your Own Review
You're reviewing:Satellite In-Line Amplifier - 900 to 2400MHz - 20 dB
Your Rating

Proposition 65

WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to


Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union. It stands for Restriction of Hazardous Substances Directive.

REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment. It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.


The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community. It stands for Wate Electrical and Electronic Equipment Directive.

* The following information is for information purposes only. It does not guarantee that the product adheres to the following standards. Please check the product description for specific certifications.

Q: Where should I install the coax amplifier?

A: Amplifiers should be installed as close as possible to the signal source. For in-line amplifiers outside next to the antenna or satellite dish would be best. Wall powered amplifiers should be installed where the signal line enters the building.