66 Wiring Block - 12 Jacks - 6P4C
| Quantity Discount Pricing | ||||
|---|---|---|---|---|
| 1-2 | 3-9 | 10-24 | 25-49 | 50+ |
| $80.38 | $75.85 | $71.40 | $67.02 | $62.70 |
Punch Down Block - 66 Wiring Block - 12 Jacks - 6P4C
A 66 block is a punchdown block containing rows of four IDC style clips. It is used for terminating 22-26 AWG solid copper cross-connect station wiring for many types of phone systems. Bridge clips are required to complete the circuit between the left and right side of the 66 block.
Features:
- 6P4C 8 Jack configuration
- Pre-terminated
- Hinged cover and bracket included
- Factory tested
Proposition 65
WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
RoHS*
Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union. It stands for Restriction of Hazardous Substances Directive.
REACH*
REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment. It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.
WEEE*
The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community. It stands for Wate Electrical and Electronic Equipment Directive.
* The following information is for information purposes only. It does not guarantee that the product adheres to the following standards. Please check the product description for specific certifications.
Q: What is the difference between a 66 and 110 block?
A: While both are punchdown blocks can run telecommunications wiring 110 blocks are the newer version and are able to run telecom and data communications reliably. 110 blocks enable the twist of the cable to be maintained up to the termination point.
Q: What does pre-wired mean?
A: Pre-wired 66 blocks are internally wired and allow you to only have to punch down the incoming service. A telco cable or line cord is then plugged in for the premise wiring. This saves time during installation.
Q: What type of wire should be used?
A: The wire type used should be 22-26 AWG solid copper wiring.
Q: What kind of tool is used to punch down the wire?
A: An impact punch-down tool is highly recommended. This will punch the wire down and cut it in one motion saving time and gives a much cleaner install.
