The 20dB In-Line Amplifier are used to boost the signal from your antenna to your TV or splitter. Simply install the amplifier at the antenna or signal source for an instant 20dB boost. In-line amplifiers are required when the signal is too weak or for long cable runs over 100 feet. This amplifier supports signals from 50 to 2150 MHz.

Features:

20dB +/- 1dB Gain
Line Powered
Power Passing
Low Noise Figure
Outdoor Rated
Bandwidth 50 to 2150 MHz
Power Consumption: 12 - 18VDC 50mA
Will not work on an unpowered line.

Reviews 1

Frequent Q&A

Q: Where should I install the coax amplifier?

A: Amplifiers should be installed as close as possible to the signal source. For in-line amplifiers outside next to the antenna or satellite dish would be best. Wall powered amplifiers should be installed where the signal line enters the building.

Specification

Features & Specs
Connector A	The type of connector on side A?	F-Type Female
Connector B	The type of connector on side B ?	F-Type Female
Signal Gain	Signal gain provided by this amplifier?	20 dB
Frequency Range	Frequencies supported by this amplifier?	50 to 2150 MHz
Power Source	How this amplifier is powered?	Line Powered