IR over HDMI Control Kit - Single Band
| Quantity Discount Pricing | ||||
|---|---|---|---|---|
| 1-2 | 3-5 | 6-7 | 8-9 | 10+ |
| $32.39 | $30.49 | $28.72 | $26.98 | $25.27 |
Infrared Remote over HDMI Control Kit - Single Band
This IR over HDMI control kit allows the user to control audio/video devices that are not in direct line of sight of the remote control. It does this by using the HDMI cable's CEC channel to transmit the IR signal. You can switch between CEC or IR mode. To connect the IR control kit, place both ends of the HDMI cable with the supplied HDMI IR adapters. Connect the IR TX pigtail to the HDMI IR adapter at the source end (Blu-ray player, etc.) and then the IR RX pigtail to the HDMI IR adapter at the display end (HDTV). The IR control kit allows extensions up to 300 feet and can also be used on HDMI switches, splitters, or HDMI extenders.
Features
- Allows IR control over any HDMI cable
- Control your source device, such as a Blu-ray player even when it's in a closed cabinet or room
- Can be used on HDMI cables, HDMI switches, HDMI splitters, and HDMI extenders
- Distances up to 300 ft.
- No power needed
- IR or CEC configurable
- IR kit includes: one IR Emitter, one IR Target, two HDMI IR adapters
- Does not support dual band remotes
Proposition 65
WARNING: This product can expose you to chemicals including phthalates, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
RoHS*
Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment in the European Union. It stands for Restriction of Hazardous Substances Directive.
REACH*
REACH, a European Union regulation addresses the production and use of chemical substances and their potential impacts on both human health and the environment. It stands for Registration, Evaluation, Authorisation, and Restriction of chemicals.
WEEE*
The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods in the European community. It stands for Wate Electrical and Electronic Equipment Directive.
* The following information is for information purposes only. It does not guarantee that the product adheres to the following standards. Please check the product description for specific certifications.
Q: What are the different parts of an IR System?
Infrared Target
This device picks up the infrared signal from your remote control just like a TV or VCR. It encodes the infrared signal into a signal suitable for transmission. Receivers must be located in the room you wish to use the remote control. The wire from the receiver to the connecting block needs at least three available conductors and can be several hundred feet long. Cat5/Cat6 wire work fine.
Hub
This is simply a place for all the parts to plug in or connect to. Connecting blocks are usually classified based on the number of ports. All connecting blocks can support many IR receivers wired in parallel. Connecting blocks are usually located near the equipment that is to be controlled along with the power supply and emitters.
Infrared Emitters
IR Emitters generally 'stick' onto the front of the device you want to control. You with need one emitter for each device. 'Dual' emitters have two emitters and one plug so they only take up one jack of the connecting block. All emitters come with long cords and double-stick tape.
Q: My remote is working sporadically what could be the problem?
A: The most likely problem is you have a signal band IR target and your remote is a dual band remote. You will need to upgrade your current IR Target with a Dual Band Target.
Q: Why do I need a Plasma Proof Target?
A: Some plasma and LCD TVs emit broad-spectrum infrared noise. This can cause issues with transmitting the proper IR signals back to the hub.
