Are you looking for a quick and easy DIY installation or repair for your coax cable? Our UHF Male Crimp connector for RG8, RG213, & LMR-400 will provide a simple solution for your wiring needs. The 2 piece connector is pre-installed with a solder cup. The only other piece to the connector is the crimp ferrule. For this installation you will need: A coax stripper, coax cable, a soldering iron, a crimp tool, and the UHF connector. Keep in mind, you will want to make sure that your coax stripper, crimp tool, and connector match the coax cable that you are installing. Start by inserting the ferrule over the outer jacket of the cable. Then, using your cable stripper, strip back the outer jacket and dielectric. The advantage of using a cable stripper is that it will strip back the jacket and dielectric at the same time. Pull back the braided shield and Insert the connector housing onto the cable. Solder the center conductor to the solder cup to make termination. Then, slide up the ferrule to the base of the connector, folding the shield with it. Crimp the ferrule onto the outer jacket to complete termination. Congratulations, you have successfully installed the UHF connector. For all of your cable and connector needs, choose Show Me Cables